Products & Shop

JBL ProFlora Bio80 eco
Bio-CO2 fertiliser system for healthy plant growth in aquariums

        Product information sheet Instructions
        There are successor products for this item:
        PROFLORA Bio80 eco
        • Natural CO2 fertilisation for 40 days: healthy plant growth, less algae. Bio-CO₂ starter set for aquariums from 12-80 l
        • Simple to install: ready for use within a few minutes
        • Natural: CO2 production from biological fermentation process. High yield: steady production of CO2 for 40 days thanks to immediate and long-term buffer system, refillable
        • No pressurised gas cylinder needed, special CO2 resistant hose
        • Package contents: bio-CO2 fertiliser system, ProFlora bio 80 eco, incl. storage cylinder, bio component, 2 m special CO2 hose, suction holder, air stone
        Find out more
        Price: 0,00 €
        Recommended retail price incl. VAT
        Instructions
        Product information

        Nutrition for aquarium plants
        Healthy plants are important in every aquarium. Plants provide the aquarium with vital oxygen for the aquarium inhabitants, prevent algae growth and remove problem-causing substances.

        Healthy plants = healthy fish
        Healthy plants prevent algae growth, supply oxygen, remove pollutants, offer hiding places and reduce pathogens.

        For the plants to flourish the following demands need to be met:
        Light as an energy source for the photosynthesis of CO2, nutrients and trace elements to promote growth.

        JBL plant fertilisers supply the plants with all their main nutrients and essential trace elements through the water. This way the plants can absorb all the required nutrients they need over the leaves and roots.

        Details
        This product is unfortunately no longer available

        JBL ProFlora Bio80 eco

        Art. no.:
        6304000
        EAN Code:
        4014162630407
        Range:
        30-80 l
        Volume packaging:
        3.73 l
        Gross weight:
        356.5 g
        Net weight:
        266 g
        Weight factor:
        1000
        Packaging dimensions (l/h/w):
        90/346/120 mm

        Properties

        Electronic label / illuminant

        Mercury: No
        Dimmable: No

        Technical Data

        capacity from - to:30-80
        capacity in days:40 d
        capacity tank length:60-100 cm
        FAQ
        Where did my algae come from?

        Algae problems in an aquarium can never be traced to just one factor or general condition, and instead, are always the result of a combination of different factors, which include light, fertilization, water changes – specifically, how often and how much – feeding, fish population and, of course, the specific water parameters.

        According to analyses that were performed over a course of a number of years, red algae, at least the common brush algae and beard algae, occur in descending order at the following parameters:

        1) too little carbon dioxide (in relationship to 100 % of the measured tank); the pH level should be in the slightly acetic range, depending on the carbonate hardness, in every case.
        2) elevated phosphate levels (over 90 %); phosphate limitation by means of JBL PhosEx ultra is often helpful here.
        3) too little and too irregular fertilization (there should always be traces of iron at least).
        4) insufficient water changes; a weekly water change of over 30 % is recommended for algae problems.
        5) not enough fast-growing plants.

        JBL ProFlora bio: When does fermentation begin with my BioCO2?

        The point at which the CO2 fermentation begins depends not only on the room temperature (22.5 °C and above is ideal), but also on the temperature in the reaction vessel and the temperature you started with when creating your new fermentation batch (25°C is ideal). Fermentation normally begins latest after 48 h. If CO2 production still hasn’t occurred, as in your case, you could try adding some more microorganisms. As an alternative, you can also add approx. the same amount of dry yeast.

        How do I clean the reaction vessel of the ProFlora BioCo2 set properly?

        Cleaning needs to be done by hand. A dishwasher may damage the plastic. Use a washing-up brush, bottle brush or the JBL WishWash instead. JBL PROCLEAN POWER or JBL PROCLEAN AQUA can be used as a cleaning solution to remove coarse dirt beforehand.

        The fermentation starter of the JBL BioRefills won’t take off.

        Please bear in mind that the microorganisms are sensitive. They need heat for an optimal start and optimal work.

        Fill the reaction vessel with approx. 25 °C warm water after adding component 1. Then add the microorganisms and close the reaction vessel. Shake the vessel vigorously, making sure to seal the opening with your finger. Then place the reaction vessel in the Thermobox (applies to ProFlora bio160). After no later than 48 hours, the reaction should have started.

        Does the use of bubble stones and a strong current expel the important plant nutrient, CO2, from the water?

        During aeration and/or when there is a strong current, a gas equilibrium is achieved between the ambient air and the water. As a result a corresponding but very low CO2 content occurs too. BUT this low CO2 content is far too low to for most aquarium plants to thrive. The aquarium owner is therefore dependent on an additional CO2 supply by a CO2 fertiliser system. The higher CO2 content this achieves is reduced or, as commonly referred to in aquatics, expelled by the aeration and strong current. Therefore well planted aquariums should only be slightly aerated at night, if required.

        Download

        Instructions

        Additional product information and downloads

        safety instructions

        • safety instruction for water conditioners
          • Filename:
            safety_instructions_Wasseraufbereitung.pdf
          Download
        spare parts

        bio80 eco reaction bottle 
        accessories

        PROFLORA BioRefill 

        Refill set for bio-CO2 systems

        Customer reviews

        Reviews

        0 Reviews

        Your opinion is important to us
        specialist dealers near you
        Sustainability at JBL
        Download catalogue

        A word about cookies before we continue

        The JBL Homepage also uses several types of cookies to provide you with full functionality and many services: We require technical and functional cookies to ensure that everything works when you visit this website. We also use cookies for marketing purposes. This ensures that we recognise you when you visit our extensive site again, that we can measure the success of our campaigns and that the personalisation cookies allow us to address you individually and directly, adapted to your needs - even outside our website. You can determine at any time - even at a later date - which cookies you allow and which you do not allow (more on this under "Change settings").

        The JBL website uses several types of cookies to provide you with full functionality and many services: Technical and functional cookies are absolutely necessary so that everything works when you visit this website. In addition, we use cookies for marketing purposes. You can determine at any time - even at a later date - which cookies you allow and which you do not (more on this under "Change settings").

        Our data protection declaration tells you how we process personal data and what purposes we use the data processing for. tells you how we process personal data and what purposes we use the data processing for. Please confirm the use of all cookies by clicking "Accept" - and you're on your way.

        Are you over 16 years old? Then confirm the use of all cookies with "Noticed" and you are ready to go.

        Change settings
        Only absolutely necessary
        Allow all

        Cookie settings

        Historie anzeigen
        Cancel Save

        PUSH messages from JBL

        What are PUSH messages? As part of the W3C standard, web notifications define an API for end-user notifications that are sent to the user's desktop and/or mobile devices via the browser. Notifications appear on the end devices as they are familiar to the end user from apps installed on the device (e.g. emails). Notifications appear on the end user’s device, just like an app (e.g. for emails) installed on the device.

        These notifications enable a website operator to contact its users whenever they have a browser open - it doesn’t matter whether the user is currently visiting the website or not.

        To be able to send web push notifications, all you need is a website with a web push code installed. This allows brands without apps to take advantage of many of the benefits of push notifications (personalised real-time communications at just the right moment).

        Web notifications are part of the W3C standard and define an API for end user notifications. A notification makes it possible to inform the user about an event, such as a new blog post, outside the context of a website.

        JBL GmbH & Co. KG provides this service free of charge, and it is easy to activate or deactivate.